Searched refs:panic (Results 76 - 100 of 392) sorted by relevance

1234567891011>>

/gem5/src/arch/x86/insts/
H A Dstatic_inst.hh132 panic("Tried to merge with unrecognized size %d.\n", size);
154 panic("Tried to pick with unrecognized size %d.\n", size);
175 panic("Tried to pick with unrecognized size %d.\n", size);
/gem5/src/dev/
H A Disa_fake.cc87 panic("invalid access size! Device being accessed by cache?\n");
113 panic("invalid access size: %u\n", pkt->getSize());
141 panic("invalid access size!\n");
H A Dio_device.cc62 panic("Pio port of %s not connected to anything!", name());
/gem5/src/dev/storage/
H A Dide_ctrl.cc124 panic("IDE controllers support a maximum "
168 panic("Unable to find disk based on pointer %#x\n", disk);
206 panic("Invalid PCI configuration read for size 1 at offset: %#x!\n",
230 panic("Invalid PCI configuration read for size 2 offset: %#x!\n",
245 panic("No 32bit reads implemented for this device.");
251 panic("invalid access size(?) for PCI configspace!\n");
281 panic("Invalid PCI configuration write "
305 panic("Invalid PCI configuration write "
321 panic("Write of unimplemented PCI config. register: %x\n", offset);
325 panic("invali
[all...]
H A Dide_disk.cc100 panic("Bad IDE image size: 0\n");
178 panic("Invalid device ID: %#x\n", id);
205 panic("Access to unset controller!\n");
223 panic("Data read of unsupported size %d.\n", size);
253 panic("Invalid IDE command register offset: %#x\n", offset);
264 panic("Invalid IDE control register offset: %#x\n", offset);
279 panic("Data write of unsupported size %d.\n", size);
310 panic("Invalid IDE command register offset: %#x\n", offset);
320 panic("Invalid IDE control register offset: %#x\n", offset);
350 panic("Inconsisten
[all...]
/gem5/src/base/
H A Dpollevent.cc157 panic("Event does not exist. Cannot remove.");
164 panic("Event already scheduled!");
211 panic("fcntl(%d, %d, %s): \"%s\" when setting up async IO.\n",
222 panic("fcntl(%d, %d): \"%s\" when setting up async IO.\n",
/gem5/src/cpu/
H A Dfunc_unit.cc69 panic("FuncUnit: you don't really want a zero-cycle latency do you?");
H A Dexec_context.hh241 panic("ExecContext::readMem() should be overridden\n");
255 panic("ExecContext::initiateMemRead() should be overridden\n");
275 panic("ExecContext::amoMem() should be overridden\n");
286 panic("ExecContext::initiateMemAMO() should be overridden\n");
/gem5/src/arch/generic/
H A Dtlb.cc43 panic("Generic translation shouldn't be used in full system mode.\n");
/gem5/src/dev/sparc/
H A Ddtod.cc77 panic("Dumb tod device doesn't support writes\n");
/gem5/src/arch/riscv/
H A Disa.cc80 panic("Illegal HPM counter %d\n", hpmcounter);
92 panic("Unknown privilege level %d\n", miscRegFile[MISCREG_PRV]);
103 panic("Illegal CSR index %#x\n", misc_reg);
173 panic("Illegal CSR index %#x\n", misc_reg);
/gem5/src/arch/x86/linux/
H A Dsystem.cc81 panic("Command line \"%s\" is longer than %d characters.\n",
/gem5/src/arch/x86/
H A Dpseudo_inst.cc78 panic("Page fault at addr %#x\n\tInterrupt handler stack:\n"
H A Dinterrupts.cc183 panic("Accessed reserved register field %#x.\n", paddr);
196 panic("Accessed more than one register at a time in the APIC!\n");
213 panic("Accessed more than one register at a time in the APIC!\n");
279 panic("Local APICs can't be moved between CPUs"
325 panic("Local apic got unknown interrupt message at offset %#x.\n",
376 panic("Local APIC Trigger Mode registers are unimplemented.\n");
380 panic("Local APIC Arbitration Priority register unimplemented.\n");
383 panic("Local APIC Processor Priority register unimplemented.\n");
415 panic("Local APIC In-Service registers are unimplemented.\n");
419 panic("Loca
[all...]
/gem5/src/mem/ruby/slicc_interface/
H A DAbstractCacheEntry.hh57 { panic("getDataBlk() not implemented!"); }
/gem5/src/cpu/testers/traffic_gen/
H A Dtrace_gen.cc64 panic("Failed to read packet header from trace\n");
66 panic("Trace was recorded with a different tick frequency %d\n",
/gem5/src/arch/sparc/
H A Dvtophys.cc54 // hypervisor) Either case is rare, so we'll just panic.
56 panic("vtophys() without context on SPARC largly worthless\n");
124 panic("couldn't translate %#x\n", addr);
/gem5/src/dev/mips/
H A Dmalta_io.cc87 panic("MaltaIO::read(...) not implemented inside malta_io.cc");
94 panic("MaltaIO::write(...) not implemented inside malta_io.cc");
/gem5/src/arch/alpha/linux/
H A Dsystem.cc85 panic("Could not determine start location of kernel");
115 panic("could not find dp264_mv\n");
124 kernelPanicEvent = addKernelFuncEventOrPanic<BreakPCEvent>("panic");
145 // Disable for now as it runs into panic() calls in VPTr methods
/gem5/src/dev/x86/
H A Dcmos.cc60 panic("Read from undefined CMOS port.\n");
79 panic("Write to undefined CMOS port.\n");
/gem5/src/arch/arm/
H A Dinterrupts.hh95 panic("int_num out of bounds\n");
98 panic("No support for other interrupt indexes\n");
110 panic("int_num out of bounds\n");
113 panic("No support for other interrupt indexes\n");
219 panic("Interrupt number out of range.\n");
264 panic("intStatus and interrupts not in sync\n");
/gem5/src/dev/pci/
H A Dcopy_engine.cc124 panic("CopyEngine::getPort: unknown index %d\n", idx);
164 panic("Resume, Abort, and Suspend are not supported\n");
175 panic("Invalid PCI memory access to unmapped memory.\n");
183 panic("Unknown size for MMIO access: %d\n", pkt->getSize());
213 panic("Read request to unknown register number: %#x\n", daddr);
229 panic("Access to channel %d (device only configured for %d channels)",
285 panic("Read request to unknown channel register number: (%d)%#x\n",
299 panic("Invalid PCI memory access to unmapped memory.\n");
327 panic("Unknown size for MMIO access: %d\n", size);
342 panic("Rea
[all...]
/gem5/src/dev/arm/
H A Dpl111.cc147 panic("LCD register at offset %#x is Write-Only\n", daddr);
177 panic("CLCD register at offset %#x is Write-Only\n", daddr);
203 panic("Tried to read CLCD register at offset %#x that "
220 panic("CLCD controller read size too big?\n");
248 panic("PL111 CLCD controller write size too big?\n");
304 panic("Interrupting on vcomp not supported\n");
313 panic("LCD register at offset %#x is Read-Only\n", daddr);
316 panic("LCD register at offset %#x is Read-Only\n", daddr);
327 panic("LCD register at offset %#x is Read-Only\n", daddr);
330 panic("LC
[all...]
H A Dpl011.cc147 panic("Tried to read PL011 at offset %#x that doesn't exist\n", daddr);
162 panic("Uart read size too big?\n");
198 panic("Uart write size too big?\n");
247 // DMA is not supported, so panic if anyome tries to enable it.
250 panic("Tried to enable DMA on PL011\n");
255 panic("Tried to write PL011 at offset %#x that doesn't exist\n", daddr);
/gem5/src/dev/net/
H A Dethertap.cc280 panic("TapListener(accept): cannot accept if we're not listening!");
408 panic("Couldn't open %s.\n", p->tun_clone_device);
416 panic("Failed to access tap device %s.\n", ifr.ifr_name);
433 panic("Error polling for tap data.\n");
443 panic("Failed to read from tap device.\n");
462 panic("Failed to write data to tap device.\n");
468 panic("Failed when polling to write data to tap device.\n");

Completed in 29 milliseconds

1234567891011>>