/gem5/src/arch/x86/insts/ |
H A D | static_inst.hh | 132 panic("Tried to merge with unrecognized size %d.\n", size); 154 panic("Tried to pick with unrecognized size %d.\n", size); 175 panic("Tried to pick with unrecognized size %d.\n", size);
|
/gem5/src/dev/ |
H A D | isa_fake.cc | 87 panic("invalid access size! Device being accessed by cache?\n"); 113 panic("invalid access size: %u\n", pkt->getSize()); 141 panic("invalid access size!\n");
|
H A D | io_device.cc | 62 panic("Pio port of %s not connected to anything!", name());
|
/gem5/src/dev/storage/ |
H A D | ide_ctrl.cc | 124 panic("IDE controllers support a maximum " 168 panic("Unable to find disk based on pointer %#x\n", disk); 206 panic("Invalid PCI configuration read for size 1 at offset: %#x!\n", 230 panic("Invalid PCI configuration read for size 2 offset: %#x!\n", 245 panic("No 32bit reads implemented for this device."); 251 panic("invalid access size(?) for PCI configspace!\n"); 281 panic("Invalid PCI configuration write " 305 panic("Invalid PCI configuration write " 321 panic("Write of unimplemented PCI config. register: %x\n", offset); 325 panic("invali [all...] |
H A D | ide_disk.cc | 100 panic("Bad IDE image size: 0\n"); 178 panic("Invalid device ID: %#x\n", id); 205 panic("Access to unset controller!\n"); 223 panic("Data read of unsupported size %d.\n", size); 253 panic("Invalid IDE command register offset: %#x\n", offset); 264 panic("Invalid IDE control register offset: %#x\n", offset); 279 panic("Data write of unsupported size %d.\n", size); 310 panic("Invalid IDE command register offset: %#x\n", offset); 320 panic("Invalid IDE control register offset: %#x\n", offset); 350 panic("Inconsisten [all...] |
/gem5/src/base/ |
H A D | pollevent.cc | 157 panic("Event does not exist. Cannot remove."); 164 panic("Event already scheduled!"); 211 panic("fcntl(%d, %d, %s): \"%s\" when setting up async IO.\n", 222 panic("fcntl(%d, %d): \"%s\" when setting up async IO.\n",
|
/gem5/src/cpu/ |
H A D | func_unit.cc | 69 panic("FuncUnit: you don't really want a zero-cycle latency do you?");
|
H A D | exec_context.hh | 241 panic("ExecContext::readMem() should be overridden\n"); 255 panic("ExecContext::initiateMemRead() should be overridden\n"); 275 panic("ExecContext::amoMem() should be overridden\n"); 286 panic("ExecContext::initiateMemAMO() should be overridden\n");
|
/gem5/src/arch/generic/ |
H A D | tlb.cc | 43 panic("Generic translation shouldn't be used in full system mode.\n");
|
/gem5/src/dev/sparc/ |
H A D | dtod.cc | 77 panic("Dumb tod device doesn't support writes\n");
|
/gem5/src/arch/riscv/ |
H A D | isa.cc | 80 panic("Illegal HPM counter %d\n", hpmcounter); 92 panic("Unknown privilege level %d\n", miscRegFile[MISCREG_PRV]); 103 panic("Illegal CSR index %#x\n", misc_reg); 173 panic("Illegal CSR index %#x\n", misc_reg);
|
/gem5/src/arch/x86/linux/ |
H A D | system.cc | 81 panic("Command line \"%s\" is longer than %d characters.\n",
|
/gem5/src/arch/x86/ |
H A D | pseudo_inst.cc | 78 panic("Page fault at addr %#x\n\tInterrupt handler stack:\n"
|
H A D | interrupts.cc | 183 panic("Accessed reserved register field %#x.\n", paddr); 196 panic("Accessed more than one register at a time in the APIC!\n"); 213 panic("Accessed more than one register at a time in the APIC!\n"); 279 panic("Local APICs can't be moved between CPUs" 325 panic("Local apic got unknown interrupt message at offset %#x.\n", 376 panic("Local APIC Trigger Mode registers are unimplemented.\n"); 380 panic("Local APIC Arbitration Priority register unimplemented.\n"); 383 panic("Local APIC Processor Priority register unimplemented.\n"); 415 panic("Local APIC In-Service registers are unimplemented.\n"); 419 panic("Loca [all...] |
/gem5/src/mem/ruby/slicc_interface/ |
H A D | AbstractCacheEntry.hh | 57 { panic("getDataBlk() not implemented!"); }
|
/gem5/src/cpu/testers/traffic_gen/ |
H A D | trace_gen.cc | 64 panic("Failed to read packet header from trace\n"); 66 panic("Trace was recorded with a different tick frequency %d\n",
|
/gem5/src/arch/sparc/ |
H A D | vtophys.cc | 54 // hypervisor) Either case is rare, so we'll just panic. 56 panic("vtophys() without context on SPARC largly worthless\n"); 124 panic("couldn't translate %#x\n", addr);
|
/gem5/src/dev/mips/ |
H A D | malta_io.cc | 87 panic("MaltaIO::read(...) not implemented inside malta_io.cc"); 94 panic("MaltaIO::write(...) not implemented inside malta_io.cc");
|
/gem5/src/arch/alpha/linux/ |
H A D | system.cc | 85 panic("Could not determine start location of kernel"); 115 panic("could not find dp264_mv\n"); 124 kernelPanicEvent = addKernelFuncEventOrPanic<BreakPCEvent>("panic"); 145 // Disable for now as it runs into panic() calls in VPTr methods
|
/gem5/src/dev/x86/ |
H A D | cmos.cc | 60 panic("Read from undefined CMOS port.\n"); 79 panic("Write to undefined CMOS port.\n");
|
/gem5/src/arch/arm/ |
H A D | interrupts.hh | 95 panic("int_num out of bounds\n"); 98 panic("No support for other interrupt indexes\n"); 110 panic("int_num out of bounds\n"); 113 panic("No support for other interrupt indexes\n"); 219 panic("Interrupt number out of range.\n"); 264 panic("intStatus and interrupts not in sync\n");
|
/gem5/src/dev/pci/ |
H A D | copy_engine.cc | 124 panic("CopyEngine::getPort: unknown index %d\n", idx); 164 panic("Resume, Abort, and Suspend are not supported\n"); 175 panic("Invalid PCI memory access to unmapped memory.\n"); 183 panic("Unknown size for MMIO access: %d\n", pkt->getSize()); 213 panic("Read request to unknown register number: %#x\n", daddr); 229 panic("Access to channel %d (device only configured for %d channels)", 285 panic("Read request to unknown channel register number: (%d)%#x\n", 299 panic("Invalid PCI memory access to unmapped memory.\n"); 327 panic("Unknown size for MMIO access: %d\n", size); 342 panic("Rea [all...] |
/gem5/src/dev/arm/ |
H A D | pl111.cc | 147 panic("LCD register at offset %#x is Write-Only\n", daddr); 177 panic("CLCD register at offset %#x is Write-Only\n", daddr); 203 panic("Tried to read CLCD register at offset %#x that " 220 panic("CLCD controller read size too big?\n"); 248 panic("PL111 CLCD controller write size too big?\n"); 304 panic("Interrupting on vcomp not supported\n"); 313 panic("LCD register at offset %#x is Read-Only\n", daddr); 316 panic("LCD register at offset %#x is Read-Only\n", daddr); 327 panic("LCD register at offset %#x is Read-Only\n", daddr); 330 panic("LC [all...] |
H A D | pl011.cc | 147 panic("Tried to read PL011 at offset %#x that doesn't exist\n", daddr); 162 panic("Uart read size too big?\n"); 198 panic("Uart write size too big?\n"); 247 // DMA is not supported, so panic if anyome tries to enable it. 250 panic("Tried to enable DMA on PL011\n"); 255 panic("Tried to write PL011 at offset %#x that doesn't exist\n", daddr);
|
/gem5/src/dev/net/ |
H A D | ethertap.cc | 280 panic("TapListener(accept): cannot accept if we're not listening!"); 408 panic("Couldn't open %s.\n", p->tun_clone_device); 416 panic("Failed to access tap device %s.\n", ifr.ifr_name); 433 panic("Error polling for tap data.\n"); 443 panic("Failed to read from tap device.\n"); 462 panic("Failed to write data to tap device.\n"); 468 panic("Failed when polling to write data to tap device.\n");
|