mem: Update DRAM configuration names

Names of DRAM configurations were updated to reflect both
the channel and device data width.

Previous naming format was:
<DEVICE_TYPE>_<DATA_RATE>_<CHANNEL_WIDTH>

The following nomenclature is now used:
<DEVICE_TYPE>_<DATA_RATE>_<n>x<w>
where n = The number of devices per rank on the channel
x = Device width

Total channel width can be calculated by n*w

Example:
A 64-bit DDR4, 2400 channel consisting of 4-bit devices:
n = 16
w = 4
The resulting configuration name is:
DDR4_2400_16x4

Updated scripts to match new naming convention.

Added unique configurations for DDR4 for:
1) 16x4
2) 8x8
3) 4x16

Change-Id: Ibd7f763b7248835c624309143cb9fc29d56a69d1
Reviewed-by: Radhika Jagtap <radhika.jagtap@arm.com>
Reviewed-by: Curtis Dunham <curtis.dunham@arm.com>

tests: Remove working dir assumption in tgen tests

The traffic generator tests currently assume that they are run from
the root of the source directory. This sometimes breaks tests when
they are run using the new test framework.

Change-Id: I6538a7902694c5d2c980295e076ea1c09acc4291
Signed-off-by: Andreas Sandberg <andreas.sandberg@arm.com>
Reviewed-by: Curtis Dunham <curtis.dunham@arm.com>

mem: Move crossbar default latencies to subclasses

This patch introduces a few subclasses to the CoherentXBar and
NoncoherentXBar to distinguish the different uses in the system. We
use the crossbar in a wide range of places: interfacing cores to the
L2, as a system interconnect, connecting I/O and peripherals,
etc. Needless to say, these crossbars have very different performance,
and the clock frequency alone is not enough to distinguish these
scenarios.

Instead of trying to capture every possible case, this patch
introduces dedicated subclasses for the three primary use-cases:
L2XBar, SystemXBar and IOXbar. More can be added if needed, and the
defaults can be overridden.

mem: Rename Bus to XBar to better reflect its behaviour

This patch changes the name of the Bus classes to XBar to better
reflect the actual timing behaviour. The actual instances in the
config scripts are not renamed, and remain as e.g. iobus or membus.

As part of this renaming, the code has also been clean up slightly,
making use of range-based for loops and tidying up some comments. The
only changes outside the bus/crossbar code is due to the delay
variables in the packet.

tests: Reflect name change in DRAM tests

This patch reflects the recent name change in the DRAM TrafficGen
tests and also tidies up the test directory.