system.terminal (9005:f681719e2e99) system.terminal (9885:afd9ea6101d9)
1[ 0.000000] Linux version 2.6.38.8-gem5 (saidi@zeep) (gcc version 4.5.2 (Sourcery G++ Lite 2011.03-41) ) #1 SMP Mon Aug 15 21:18:38 EDT 2011
2
3[ 0.000000] CPU: ARMv7 Processor [350fc000] revision 0 (ARMv7), cr=10c53c7f
4
5[ 0.000000] CPU: VIPT nonaliasing data cache, VIPT nonaliasing instruction cache
6
7[ 0.000000] Machine: ARM-RealView PBX
8

--- 56 unchanged lines hidden (view full) ---

65[ 0.000000] RCU-based detection of stalled CPUs is disabled.
66
67[ 0.000000] NR_IRQS:128
68
69[ 0.000000] sched_clock: 32 bits at 24MHz, resolution 41ns, wraps every 178956ms
70
71[ 0.000000] Console: colour dummy device 80x30
72
1[ 0.000000] Linux version 2.6.38.8-gem5 (saidi@zeep) (gcc version 4.5.2 (Sourcery G++ Lite 2011.03-41) ) #1 SMP Mon Aug 15 21:18:38 EDT 2011
2
3[ 0.000000] CPU: ARMv7 Processor [350fc000] revision 0 (ARMv7), cr=10c53c7f
4
5[ 0.000000] CPU: VIPT nonaliasing data cache, VIPT nonaliasing instruction cache
6
7[ 0.000000] Machine: ARM-RealView PBX
8

--- 56 unchanged lines hidden (view full) ---

65[ 0.000000] RCU-based detection of stalled CPUs is disabled.
66
67[ 0.000000] NR_IRQS:128
68
69[ 0.000000] sched_clock: 32 bits at 24MHz, resolution 41ns, wraps every 178956ms
70
71[ 0.000000] Console: colour dummy device 80x30
72
73[ 0.000168] Calibrating delay loop (skipped) preset value.. 3997.69 BogoMIPS (lpj=19988480)
73[ 0.000190] Calibrating delay loop (skipped) preset value.. 3997.69 BogoMIPS (lpj=19988480)
74
74
75[ 0.000223] pid_max: default: 32768 minimum: 301
75[ 0.000273] pid_max: default: 32768 minimum: 301
76
76
77[ 0.000427] Mount-cache hash table entries: 512
77[ 0.000492] Mount-cache hash table entries: 512
78
78
79[ 0.000749] CPU: Testing write buffer coherency: ok
79[ 0.000841] CPU: Testing write buffer coherency: ok
80
80
81[ 0.001004] Brought up 1 CPUs
81[ 0.001127] Brought up 1 CPUs
82
82
83[ 0.001027] SMP: Total of 1 processors activated (3997.69 BogoMIPS).
83[ 0.001161] SMP: Total of 1 processors activated (3997.69 BogoMIPS).
84
84
85[ 0.001188] devtmpfs: initialized
85[ 0.001346] devtmpfs: initialized
86
86
87[ 0.002576] NET: Registered protocol family 16
87[ 0.002764] NET: Registered protocol family 16
88
88
89[ 0.003736] Serial: AMBA PL011 UART driver
89[ 0.003964] Serial: AMBA PL011 UART driver
90
90
91[ 0.003799] dev:uart0: ttyAMA0 at MMIO 0x10009000 (irq = 44) is a PL011 rev3
91[ 0.004042] dev:uart0: ttyAMA0 at MMIO 0x10009000 (irq = 44) is a PL011 rev3
92
92
93[ 0.003847] console [ttyAMA0] enabled, bootconsole disabled
94[ 0.003847] console [ttyAMA0] enabled, bootconsole disabled
93[ 0.004116] console [ttyAMA0] enabled, bootconsole disabled
94[ 0.004116] console [ttyAMA0] enabled, bootconsole disabled
95
95
96[ 0.008051] bio: create slab <bio-0> at 0
97[ 0.008728] SCSI subsystem initialized
98[ 0.008956] libata version 3.00 loaded.
99[ 0.009494] Switching to clocksource timer3
100[ 0.017073] NET: Registered protocol family 2
101[ 0.017178] IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
102[ 0.017421] TCP established hash table entries: 4096 (order: 3, 32768 bytes)
103[ 0.017555] TCP bind hash table entries: 4096 (order: 3, 32768 bytes)
104[ 0.017680] TCP: Hash tables configured (established 4096 bind 4096)
105[ 0.017710] TCP reno registered
106[ 0.017729] UDP hash table entries: 128 (order: 0, 4096 bytes)
107[ 0.017780] UDP-Lite hash table entries: 128 (order: 0, 4096 bytes)
108[ 0.017990] NET: Registered protocol family 1
109[ 0.019019] msgmni has been set to 244
110[ 0.019053] io scheduler noop registered (default)
111[ 0.021325] CLCD: RealView hardware, XVGA display
112[ 0.077800] Console: switching to colour frame buffer device 128x48
113[ 0.111168] brd: module loaded
114[ 0.113636] loop: module loaded
115[ 0.114723] scsi0 : pata_platform
116[ 0.114971] ata1: PATA max PIO0 no IRQ, using PIO polling mmio cmd 0x18000000 ctl 0x18000100
117[ 0.115596] slram: not enough parameters.
118[ 0.116179] mousedev: PS/2 mouse device common for all mice
119[ 0.116499] TCP cubic registered
120[ 0.116518] NET: Registered protocol family 17
121[ 0.116547] VFP support v0.3: implementor 41 architecture 4 part 30 variant a rev 0
122[ 0.270184] ata1.00: ATA-7: M5 IDE Disk, , max UDMA/66
123[ 0.270211] ata1.00: 1048320 sectors, multi 0: LBA
124[ 0.270240] ata1.00: configured for PIO
125[ 0.270435] scsi 0:0:0:0: Direct-Access ATA M5 IDE Disk n/a PQ: 0 ANSI: 5
126[ 0.270894] sd 0:0:0:0: [sda] 1048320 512-byte logical blocks: (536 MB/511 MiB)
127[ 0.271042] sd 0:0:0:0: [sda] Write Protect is off
128[ 0.271069] sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00
129[ 0.271142] sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
130[ 0.272256] sda: sda1
131[ 0.272427] sd 0:0:0:0: Attached scsi generic sg0 type 0
132[ 0.272843] sd 0:0:0:0: [sda] Attached SCSI disk
133[ 0.710289] input: AT Raw Set 2 keyboard as /devices/fpga:kmi0/serio0/input/input0
134[ 2.310249] input: touchkitPS/2 eGalax Touchscreen as /devices/fpga:kmi1/serio1/input/input1
135[ 2.331079] VFS: Mounted root (ext2 filesystem) on device 8:1.
136[ 2.331510] devtmpfs: mounted
137[ 2.331559] Freeing init memory: 132K
96[ 0.008382] bio: create slab <bio-0> at 0
97[ 0.009076] SCSI subsystem initialized
98[ 0.009316] libata version 3.00 loaded.
99[ 0.009872] Switching to clocksource timer3
100[ 0.017485] NET: Registered protocol family 2
101[ 0.017602] IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
102[ 0.017864] TCP established hash table entries: 4096 (order: 3, 32768 bytes)
103[ 0.018020] TCP bind hash table entries: 4096 (order: 3, 32768 bytes)
104[ 0.018166] TCP: Hash tables configured (established 4096 bind 4096)
105[ 0.018211] TCP reno registered
106[ 0.018238] UDP hash table entries: 128 (order: 0, 4096 bytes)
107[ 0.018303] UDP-Lite hash table entries: 128 (order: 0, 4096 bytes)
108[ 0.018528] NET: Registered protocol family 1
109[ 0.019574] msgmni has been set to 244
110[ 0.019617] io scheduler noop registered (default)
111[ 0.022390] CLCD: RealView hardware, XVGA display
112[ 0.069884] Console: switching to colour frame buffer device 128x48
113[ 0.095901] brd: module loaded
114[ 0.098342] loop: module loaded
115[ 0.099406] scsi0 : pata_platform
116[ 0.099658] ata1: PATA max PIO0 no IRQ, using PIO polling mmio cmd 0x18000000 ctl 0x18000100
117[ 0.100559] slram: not enough parameters.
118[ 0.101122] mousedev: PS/2 mouse device common for all mice
119[ 0.101438] TCP cubic registered
120[ 0.101464] NET: Registered protocol family 17
121[ 0.101501] VFP support v0.3: implementor 41 architecture 4 part 30 variant a rev 0
122[ 0.250198] ata1.00: ATA-7: M5 IDE Disk, , max UDMA/66
123[ 0.250238] ata1.00: 1048320 sectors, multi 0: LBA
124[ 0.250278] ata1.00: configured for PIO
125[ 0.250483] scsi 0:0:0:0: Direct-Access ATA M5 IDE Disk n/a PQ: 0 ANSI: 5
126[ 0.250963] sd 0:0:0:0: [sda] 1048320 512-byte logical blocks: (536 MB/511 MiB)
127[ 0.251128] sd 0:0:0:0: [sda] Write Protect is off
128[ 0.251166] sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00
129[ 0.251251] sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
130[ 0.252448] sda: sda1
131[ 0.252627] sd 0:0:0:0: Attached scsi generic sg0 type 0
132[ 0.253053] sd 0:0:0:0: [sda] Attached SCSI disk
133[ 0.700298] input: AT Raw Set 2 keyboard as /devices/fpga:kmi0/serio0/input/input0
134[ 2.300258] input: touchkitPS/2 eGalax Touchscreen as /devices/fpga:kmi1/serio1/input/input1
135[ 2.321157] VFS: Mounted root (ext2 filesystem) on device 8:1.
136[ 2.321633] devtmpfs: mounted
137[ 2.321685] Freeing init memory: 132K
138
139init started: BusyBox v1.15.3 (2010-05-07 01:27:07 BST)
140
141starting pid 331, tty '': '/etc/rc.d/rc.local'
142warning: can't open /etc/mtab: No such file or directory
143Thu Jan 1 00:00:02 UTC 1970
144S: devpts
145Thu Jan 1 00:00:02 UTC 1970
138
139init started: BusyBox v1.15.3 (2010-05-07 01:27:07 BST)
140
141starting pid 331, tty '': '/etc/rc.d/rc.local'
142warning: can't open /etc/mtab: No such file or directory
143Thu Jan 1 00:00:02 UTC 1970
144S: devpts
145Thu Jan 1 00:00:02 UTC 1970