system.terminal (8802:ef66a9083bc4) system.terminal (9005:f681719e2e99)
1[ 0.000000] Linux version 2.6.38.8-gem5 (saidi@zeep) (gcc version 4.5.2 (Sourcery G++ Lite 2011.03-41) ) #1 SMP Mon Aug 15 21:18:38 EDT 2011
2
3[ 0.000000] CPU: ARMv7 Processor [350fc000] revision 0 (ARMv7), cr=10c53c7f
4
5[ 0.000000] CPU: VIPT nonaliasing data cache, VIPT nonaliasing instruction cache
6
7[ 0.000000] Machine: ARM-RealView PBX
8

--- 56 unchanged lines hidden (view full) ---

65[ 0.000000] RCU-based detection of stalled CPUs is disabled.
66
67[ 0.000000] NR_IRQS:128
68
69[ 0.000000] sched_clock: 32 bits at 24MHz, resolution 41ns, wraps every 178956ms
70
71[ 0.000000] Console: colour dummy device 80x30
72
1[ 0.000000] Linux version 2.6.38.8-gem5 (saidi@zeep) (gcc version 4.5.2 (Sourcery G++ Lite 2011.03-41) ) #1 SMP Mon Aug 15 21:18:38 EDT 2011
2
3[ 0.000000] CPU: ARMv7 Processor [350fc000] revision 0 (ARMv7), cr=10c53c7f
4
5[ 0.000000] CPU: VIPT nonaliasing data cache, VIPT nonaliasing instruction cache
6
7[ 0.000000] Machine: ARM-RealView PBX
8

--- 56 unchanged lines hidden (view full) ---

65[ 0.000000] RCU-based detection of stalled CPUs is disabled.
66
67[ 0.000000] NR_IRQS:128
68
69[ 0.000000] sched_clock: 32 bits at 24MHz, resolution 41ns, wraps every 178956ms
70
71[ 0.000000] Console: colour dummy device 80x30
72
73[ 0.000000] Calibrating delay loop (skipped) preset value.. 3997.69 BogoMIPS (lpj=19988480)
73[ 0.000051] Calibrating delay loop (skipped) preset value.. 3997.69 BogoMIPS (lpj=19988480)
74
74
75[ 0.000000] pid_max: default: 32768 minimum: 301
75[ 0.000059] pid_max: default: 32768 minimum: 301
76
76
77[ 0.000000] Mount-cache hash table entries: 512
77[ 0.000116] Mount-cache hash table entries: 512
78
78
79[ 0.000000] CPU: Testing write buffer coherency: ok
79[ 0.000218] CPU: Testing write buffer coherency: ok
80
80
81[ 0.000000] Brought up 1 CPUs
81[ 0.000283] Brought up 1 CPUs
82
82
83[ 0.000000] SMP: Total of 1 processors activated (3997.69 BogoMIPS).
83[ 0.000287] SMP: Total of 1 processors activated (3997.69 BogoMIPS).
84
84
85[ 0.000000] devtmpfs: initialized
85[ 0.000332] devtmpfs: initialized
86
86
87[ 0.000001] NET: Registered protocol family 16
87[ 0.000872] NET: Registered protocol family 16
88
88
89[ 0.000002] Serial: AMBA PL011 UART driver
89[ 0.001228] Serial: AMBA PL011 UART driver
90
90
91[ 0.000002] dev:uart0: ttyAMA0 at MMIO 0x10009000 (irq = 44) is a PL011 rev3
91[ 0.001242] dev:uart0: ttyAMA0 at MMIO 0x10009000 (irq = 44) is a PL011 rev3
92
92
93[ 0.000002] console [ttyAMA0] enabled, bootconsole disabled
94[ 0.000002] console [ttyAMA0] enabled, bootconsole disabled
93[ 0.001248] console [ttyAMA0] enabled, bootconsole disabled
94[ 0.001248] console [ttyAMA0] enabled, bootconsole disabled
95
95
96[ 0.000004] bio: create slab <bio-0> at 0
97[ 0.000004] SCSI subsystem initialized
98[ 0.000004] libata version 3.00 loaded.
99[ 0.000005] Switching to clocksource timer3
100[ 0.000009] NET: Registered protocol family 2
101[ 0.000009] IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
102[ 0.000009] TCP established hash table entries: 4096 (order: 3, 32768 bytes)
103[ 0.000009] TCP bind hash table entries: 4096 (order: 3, 32768 bytes)
104[ 0.000009] TCP: Hash tables configured (established 4096 bind 4096)
105[ 0.000009] TCP reno registered
106[ 0.000009] UDP hash table entries: 128 (order: 0, 4096 bytes)
107[ 0.000009] UDP-Lite hash table entries: 128 (order: 0, 4096 bytes)
108[ 0.000009] NET: Registered protocol family 1
109[ 0.000010] msgmni has been set to 244
110[ 0.000010] io scheduler noop registered (default)
111[ 0.000011] CLCD: RealView hardware, XVGA display
112[ 0.000057] Console: switching to colour frame buffer device 128x48
113[ 0.000066] brd: module loaded
114[ 0.000068] loop: module loaded
115[ 0.000068] scsi0 : pata_platform
116[ 0.000068] ata1: PATA max PIO0 no IRQ, using PIO polling mmio cmd 0x18000000 ctl 0x18000100
117[ 0.000069] slram: not enough parameters.
118[ 0.000069] mousedev: PS/2 mouse device common for all mice
119[ 0.000069] TCP cubic registered
120[ 0.000069] NET: Registered protocol family 17
121[ 0.000069] VFP support v0.3: implementor 41 architecture 4 part 30 variant a rev 0
122[ 0.000330] ata1.00: ATA-7: M5 IDE Disk, , max UDMA/66
123[ 0.000330] ata1.00: 1048320 sectors, multi 0: LBA
124[ 0.000330] ata1.00: configured for PIO
125[ 0.000330] scsi 0:0:0:0: Direct-Access ATA M5 IDE Disk n/a PQ: 0 ANSI: 5
126[ 0.000330] sd 0:0:0:0: [sda] 1048320 512-byte logical blocks: (536 MB/511 MiB)
127[ 0.000330] sd 0:0:0:0: [sda] Write Protect is off
128[ 0.000330] sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00
129[ 0.000330] sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
130[ 0.000331] sda: sda1
131[ 0.000331] sd 0:0:0:0: Attached scsi generic sg0 type 0
132[ 0.000331] sd 0:0:0:0: [sda] Attached SCSI disk
133[ 0.001111] input: AT Raw Set 2 keyboard as /devices/fpga:kmi0/serio0/input/input0
134[ 0.003889] input: touchkitPS/2 eGalax Touchscreen as /devices/fpga:kmi1/serio1/input/input1
135[ 0.003924] VFS: Mounted root (ext2 filesystem) on device 8:1.
136[ 0.003924] devtmpfs: mounted
137[ 0.003924] Freeing init memory: 132K
96[ 0.002604] bio: create slab <bio-0> at 0
97[ 0.002813] SCSI subsystem initialized
98[ 0.002880] libata version 3.00 loaded.
99[ 0.003052] Switching to clocksource timer3
100[ 0.005417] NET: Registered protocol family 2
101[ 0.005445] IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
102[ 0.005513] TCP established hash table entries: 4096 (order: 3, 32768 bytes)
103[ 0.005542] TCP bind hash table entries: 4096 (order: 3, 32768 bytes)
104[ 0.005569] TCP: Hash tables configured (established 4096 bind 4096)
105[ 0.005574] TCP reno registered
106[ 0.005577] UDP hash table entries: 128 (order: 0, 4096 bytes)
107[ 0.005587] UDP-Lite hash table entries: 128 (order: 0, 4096 bytes)
108[ 0.005653] NET: Registered protocol family 1
109[ 0.005968] msgmni has been set to 244
110[ 0.005976] io scheduler noop registered (default)
111[ 0.006404] CLCD: RealView hardware, XVGA display
112[ 0.032955] Console: switching to colour frame buffer device 128x48
113[ 0.038422] brd: module loaded
114[ 0.039324] loop: module loaded
115[ 0.039644] scsi0 : pata_platform
116[ 0.039722] ata1: PATA max PIO0 no IRQ, using PIO polling mmio cmd 0x18000000 ctl 0x18000100
117[ 0.039946] slram: not enough parameters.
118[ 0.040131] mousedev: PS/2 mouse device common for all mice
119[ 0.040221] TCP cubic registered
120[ 0.040223] NET: Registered protocol family 17
121[ 0.040228] VFP support v0.3: implementor 41 architecture 4 part 30 variant a rev 0
122[ 0.190100] ata1.00: ATA-7: M5 IDE Disk, , max UDMA/66
123[ 0.190104] ata1.00: 1048320 sectors, multi 0: LBA
124[ 0.190110] ata1.00: configured for PIO
125[ 0.190165] scsi 0:0:0:0: Direct-Access ATA M5 IDE Disk n/a PQ: 0 ANSI: 5
126[ 0.190315] sd 0:0:0:0: [sda] 1048320 512-byte logical blocks: (536 MB/511 MiB)
127[ 0.190357] sd 0:0:0:0: [sda] Write Protect is off
128[ 0.190362] sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00
129[ 0.190382] sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
130[ 0.190738] sda: sda1
131[ 0.190789] sd 0:0:0:0: Attached scsi generic sg0 type 0
132[ 0.190928] sd 0:0:0:0: [sda] Attached SCSI disk
133[ 0.640109] input: AT Raw Set 2 keyboard as /devices/fpga:kmi0/serio0/input/input0
134[ 2.240093] input: touchkitPS/2 eGalax Touchscreen as /devices/fpga:kmi1/serio1/input/input1
135[ 2.260514] VFS: Mounted root (ext2 filesystem) on device 8:1.
136[ 2.260711] devtmpfs: mounted
137[ 2.260723] Freeing init memory: 132K
138
139init started: BusyBox v1.15.3 (2010-05-07 01:27:07 BST)
140
141starting pid 331, tty '': '/etc/rc.d/rc.local'
142warning: can't open /etc/mtab: No such file or directory
143Thu Jan 1 00:00:02 UTC 1970
144S: devpts
145Thu Jan 1 00:00:02 UTC 1970
138
139init started: BusyBox v1.15.3 (2010-05-07 01:27:07 BST)
140
141starting pid 331, tty '': '/etc/rc.d/rc.local'
142warning: can't open /etc/mtab: No such file or directory
143Thu Jan 1 00:00:02 UTC 1970
144S: devpts
145Thu Jan 1 00:00:02 UTC 1970